Chrysler 2005 Crossfire SRT6 Service Manual page 2014

9 - 90 ENGINE - ELECTRICAL DIAGNOSTICS
(P0120) THROTTLE POSITION SENSOR 1/2 CORRELATION (CONTINUED)
When Monitored and Set Condition
• When Monitored: Ignition on with no MAP Sensor DTCs set.
• Set Condition: TP Sensor signals in the Throttle Body do not correlate to the MAP Sensor signal.
TP SENSOR SIGNAL CIRCUIT(S) SHORT TO VOLTAGE
TP SENSOR SIGNAL CIRCUIT(S) SHORT TO GROUND
TP SENSOR SIGNAL CIRCUIT(S) SHORT TO ANOTHER CIRCUIT
TP SIGNAL CIRCUIT(S) OPEN
5-VOLT SUPPLY CIRCUIT SHORT TO VOLTAGE
5-VOLT SUPPLY CIRCUIT SHORTED TO GROUND
5-VOLT SUPPLY CIRCUIT OPEN
APP SENSOR 5-VOLT SUPPLY CIRCUIT SHORT TO VOLTAGE
APP SENSOR 5-VOLT SUPPLY CIRCUIT SHORT TO GROUND
SENSOR GROUND CIRCUIT OPEN
THROTTLE CONTROL MOTOR CIRCUIT(S) SHORT TO VOLTAGE
THROTTLE CONTROL MOTOR CIRCUIT(S) SHORT TO GROUND
THROTTLE CONTROL MOTOR CIRCUIT(S) OPEN
THROTTLE BODY
POWERTRAIN CONTROL MODULE
For a complete Powertrain Control Module Circuit Diagram, (Refer to 9 - ENGINE - SCHEMATICS AND DIA-
GRAMS).
Diagnostic Test
1.
CHECK FOR CURRENT DTC
Turn the ignition on.
With the DRB III , read PCM DTCs.
Is this DTC present?
Yes >> For complete diagnosis of this DTC, refer to (P0120)
ELECTRONIC THROTTLE CONTROL MOTOR PERFOR-
MANCE.
No >> Go To 2
POSSIBLE CAUSES
ZH