Stp Interface Point-To-Point - Huawei quidway s3526 series Getting Started

Command Manual - STP
Quidway S3500 Series Ethernet Switches
in Port Command Manual. &<1-10> means that the preceding parameters can be
entered up to 10 times.
Description
Using stp interface mcheck command, you can perform mcheck operation on the port
in system view.
If a port of an MSTP switch on a switching network has ever been connected to an STP
switch, the port will automatically transit to operate in STP-compatible mode. However,
when the STP switch is removed, the port stays in STP-compatible mode and cannot
automatically transit back to MSTP mode. In this case, you can perform mCheck
operation to transit the port to MSTP mode by force.
For the related command, see stp mcheck, stp mode.
Example
# Set mcheck parameter of Ethernet 0/3 in system view.
[Quidway] stp interface ethernet 0/3 mcheck

1.1.24 stp interface point-to-point

Syntax
stp interface interface-list point-to-point { force-true | force-false | auto }
undo stp interface interface-list point-to-point
View
System view
Parameter
interface-list: Ethernet port list, containing multiple Ethernet ports and expressed as
interface _list = { { interface_type interface_num | interface_name } [ to { interface_type
interface_num | interface_name } ] }&<1-10>. For detail descriptions of interface_type,
interface_num and interface_name parameters, refer to the corresponding descriptions
in Port Command Manual. &<1-10> means that the preceding parameters can be
entered up to 10 times.
force-true: Indicates the Ethernet port connected to a point-to-point link.
force-false: Indicates the Ethernet port not connected to a point-to-point link.
auto: Configure to automatically check if the link to the Ethernet port is a point-to-point
link.
Huawei Technologies Proprietary
1-23
Chapter 1 MSTP Configuration Commands