Igmp Host-Join; Igmp Host-Join Vlan - Huawei quidway s3526 series Getting Started

Command Manual - Multicast
Quidway S3500 Series Ethernet Switches
Example
# Configure that only the hosts contained in the access-list 2000 connected to the port
Ethernet0/1 in VLAN-interface10 can be added to the multicast group, which is
configured to use IGMP version 2.
[Quidway-Ethernet0/1] igmp group-policy 2000 vlan 10

4.1.7 igmp host-join

Syntax
igmp host-join group-address port { interface_type interface_ num | interface_name }
[ to { interface_type interface_ num | interface_name } ]
undo igmp host-join group-address port { interface_type interface_ num |
interface_name } [ to { interface_type interface_ num | interface_name } ]
View
VLAN interface view
Parameter
group-address: Multicast address of the multicast group that an interface will join.
port: Specify the port in the VLAN interface.
Description
Using igmp host-join command, you can enable an port in the VLAN interface of an
ethernet switch to join a multicast group. Using undo igmp host-join command, you
can disable the configuration.
By default, an interface does not join any multicast group.
On an ethernet switch, up to 64 interfaces can be configured with igmp host-join
command at best.
For the related command, see igmp group-policy.
Example
# Add port Ethernet 0/1 in VLAN-interface10 to the multicast group at 225.0.0.1.
[Quidway-Vlan-interface10] igmp host-join 225.0.0.1 port Ethernet 0/1

4.1.8 igmp host-join vlan

Syntax
igmp host-join group-address vlan vlanid
undo igmp host-join group-address vlan vlanid
Huawei Technologies Proprietary
4-6
Chapter 4 IGMP Configuration Commands