Display Current-Configuration - Huawei quidway s3526 series Getting Started

Command Manual - System Management
Quidway S3500 Series Ethernet Switches

4.2.2 display current-configuration

Syntax
display
[ interface-number ] | configuration [ system | user-interface ] ] [ | { begin | exclude |
include } regular-expression ]
View
Any view
Parameter
controller: View the configuration information of controllers.
interface: View the configuration information of interfaces.
interface-type: Type of the interface.
interface-number: Number of the interface.
configuration: View the pre-positive and post-positive configuration information.
system: View the configuration information of sysname.
user-interface: View the configuration information of user-interface.
|: Filter the configuration information to be output via regular expression.
begin: Begin with the line that matches the regular expression.
exclude: Exclude lines that match the regular expression.
include: Include lines that match the regular expression.
regular-expression: Define the regular expression.
Description
Using display current-configuration command, you can display the currently
effective configuration parameters of the switch.
By default, if some running configuration parameters are the same with the default
operational parameters, they will not be displayed.
If a user needs to authenticate whether the configurations are correct after finishing a
set of configuration, the display current-configuration command can be used to
display the running parameters. Although the user has configured some parameters,
but the related functions are not effective, they are not displayed.
When there is much configuration information, you can use the regular expression to
filter the output information. For specific rules about the regular expression, refer to the
corresponding operation manual.
For the related command, see save, reset saved-configuration and display
saved-configuration.
current-configuration
Huawei Technologies Proprietary
Chapter 4 System Maintenance Commands
[ controller |
4-5
interface interface-type