Peer; Preference - Huawei quidway s3526 series Getting Started

Command Manual - Routing Protocol
Quidway S3500 Series Ethernet Switches
[Quidway-rip] network 129.102.0.0

2.1.9 peer

Syntax
peer ip-address
undo peer ip-address
View
RIP view
Parameter
ip-address: The interface IP address of the peer router, represented in the format of
dotted decimal.
Description
Using peer command, you can configure the sending destination address of the peer
device. Using undo peer command, you can cancel the set destination address.
By default, do not send RIP packet to any destination.
RIP exchanges routing information with non-broadcasting networks in unicast view.
This command specifies the sending destination address to fit some non-broadcast
networks. Usually, it is not recommended to use this command.
Example
# Specify the sending destination address 202.38.165.1.
[Quidway-rip] peer 202.38.165.1

2.1.10 preference

Syntax
preference value
undo preference
View
RIP view
Parameter
value: Preference level, ranging from 1 to 255. By default, the value is 100.
Huawei Technologies Proprietary
2-8
Chapter 2 RIP Configuration Commands