Ntp-Service Unicast-Server - Huawei quidway s3526 series Getting Started

Command Manual - System Management
Quidway S3500 Series Ethernet Switches
interface-number: Specify the interface number and determine an interface together
with the interface-type parameter.
priority: Designate a server as the first choice.
Description
Using ntp-service unicast-peer command, you can configure NTP peer mode. Using
undo ntp-service unicast-peer command, you can cancel NTP peer mode.
By default, version number number defaults to 3, the authentication is disabled, and the
local server is not the first choice.
This command sets the remote server at ip-address as a peer of the local equipment,
which operates in symmetric active mode. ip-address specifies a host address other
than an IP address of broadcast, multicast, or reference clock. By operating in this
mode, a local device can synchronize and be synchronized by a remote server.
Example
# Configure the local equipment to synchronize or synchronized by a peer at
128.108.22.44. Set the NTP version to 3. The IP address of the NTP packets are taken
from that of Vlan-Interface1.
[Quidway] ntp-service unicast-peer 131.108.22.33 version 3 source-interface
Vlan-Interface 1

7.1.18 ntp-service unicast-server

Syntax
ntp-service unicast-server ip-address [ version number ] [ authentication-keyid
keyid ] [ source-interface { interface-name | interface-type interface-number } ]
[ priority ]
undo ntp-service unicast-server ip-address
View
System view
Parameter
ip-address: Specify the IP address of a remote server.
version: Define NTP version number.
number: NTP version number, ranging from 1 to 3.
authentication-keyid: Define authentication key.
keyid: Key ID used for transmitting messages to a remote server, ranging from 0 to
4294967295.
source-interface: Specify the name of an interface.
Huawei Technologies Proprietary
7-14
Chapter 7 NTP Configuration Commands