Memory Auto-Establish Disable - Huawei quidway s3526 series Getting Started

Command Manual - Routing Protocol
Quidway S3500 Series Ethernet Switches
Table 6-2 The description for the information displayed by the display memory limit
command
system
safety
system memory limit
auto-establish
enabled
Free Memory
The
disconnect: 0
The
reconnect: 0
The current
Normal

6.1.3 memory auto-establish disable

Syntax
memory auto-establish disable
View
System view
Parameter
None
Description
Using memory auto-establish disable command, you can disable the routing protocol
connection that is forcibly disconnected to recover automatically when the idle memory
of the Ethernet switch reaches this value. Thus, connections of all the routing protocols
will not recover when the idle memory of the Ethernet switch recovers to a safety value.
In this case, you need to restart the routing protocol to recover the connections.
By default, when the idle memory of the Ethernet switch recovers to a safety value,
connections of all the routing protocols will always recover (when the idle memory of
the Ethernet switch reduces to a lower limit, the connection will be disconnected
forcibly).
You shall use the command cautiously.
Item
memory
The safety value of the Ethernet switch memory.
The lower limit of the Ethernet switch memory.
The
automatically. (If the automatic recover is disabled, the
"auto-establish disabled" will be displayed.)
The size of the current idle memory.
times of The times of the connection disconnecting of the Ethernet
switch is 0.
times of The times of the connection reestablishment of the
Ethernet switch is 0.
state: The current state is normal. (If entering the emergent state,
the system will display "Exigence" )
Huawei Technologies Proprietary
Chapter 6 Route Capacity Configuration Commands
Description
system allows recovering
6-3
the connection