Display Vrrp - Huawei quidway s3526 series Getting Started

Command Manual - Reliability
Quidway S3500 Series Ethernet Switches

1.1.2 display vrrp

Syntax
display vrrp [ { interface | statistics } vlan-interface interface-num ]
[ virtual-router-ID ]
View
Any view.
Parameter
interface-name: Interface name, the interface form is VLAN-interface interface-num.
virtual-router-ID: VRRP virtual router ID, ranging from 1 to 255.
Description
Using display vrrp command, you can view the information about the VRRP state.
This command is used to view the information about the VRRP state and configuration
parameters. If the interface name and virtual router ID are not specified, the state
information about all the virtual routers on the switch will be displayed. If only the
interface name is specified, the state information about all the virtual routers on the
interface will be displayed. If the interface name and virtual router ID are specified, the
state information about the specified virtual router on the interface will be displayed.
Example
# Display the information about the virtual routers on VLAN-interface 1 of the switch.
[Quidway-Vlan-interface1] display vrrp
Run Method : VIRTUAL-MAC
Interface
VRID
Admin Status
Config Pri
Preempt Mode
Auth Type
Track IF
Virtual IP
Master IP
Table 1-2 Description of information generated by the command display vrrp
Run Method
Virtual IP ping
Virtual Ip Ping : Disable
: Vlan-interface1
: 1
: UP
: 100
: YES
: NONE
: Vlan-interface2
: 1.1.1.1
: 0.0.0.0
Field
Run method: real or virtual MAC method
Whether to enable to ping through virtual IP
Huawei Technologies Proprietary
Chapter 1 VRRP Configuration Commands
Adver. Timer
State
Run Pri
Delay Time
Pri Reduced
Description
1-2
: 1
: Initialize
: 90
: 0
: 10