Info-Center Monitor Channel - Huawei quidway s3526 series Getting Started

Command Manual - System Management
Quidway S3500 Series Ethernet Switches
Parameter
source interface-name: set source address of the packets sent to loghost as the
address of the interface specified by the interface-name. Normally, the interface should
be VLAN interface.
Description
Using info-center loghost source command, you can set source address of the
packets sent to loghost as the address of the interface specified by the interface-name.
Using undo info-center loghost source command, you can cancel the setting source
address of the packets sent to loghost.
This command takes effect only after the system logging is enabled.
For the related commands, see info-center enable, display info-center.
Example
# Set source address of the packets sent to loghost as the address of the VLAN
interface 1.
[Quidway] info-center loghost source vlan-interface 1

4.5.9 info-center monitor channel

Syntax
info-center monitor channel { channel-number | channel-name }
undo info-center monitor channel
View
System view
Parameter
channel-number: Channel number, ranging from 0 to 9, that is, the system has ten
channels.
channel-name: Specify the channel name. The name can be channel6, channel7,
channel8,
trapbuffer.
Description
Using info-center monitor channel command, you can configure the channel to
output the log information to the user terminal. Using undo info-center monitor
channel command, you can restore the channel to output the log information to the
user terminal to default value.
By default, Ethernet switches do not output log information to user terminal.
channel9, console,
Huawei Technologies Proprietary
4-25
Chapter 4 System Maintenance Commands
logbuffer, loghost, monitor, snmpagent,