Tracert - Huawei quidway s3526 series Getting Started

Command Manual - System Management
Quidway S3500 Series Ethernet Switches
Responses to each of the ECHO-REQUEST messages. If the response message
is not received until timeout, output "Request time out". Or display response
message bytes, packet sequence number, TTL and response time.
The final statistics, including number of sent packets, number of response packets
received, percentage of non-response packets and minimal/maximum/average
value of response time.
If the network transmission rate is too low, you can increase the response message
timeout.
For the related commands, see tracert.
Example
# Check whether the host 202.38.160.244 is reachable.
<Quidway> ping 202.38.160.244
ping 202.38.160.244 : 56 data bytes
Reply from 202.38.160.244 : bytes=56 sequence=1 ttl=255 time = 1ms
Reply from 202.38.160.244 : bytes=56 sequence=2 ttl=255 time = 2ms
Reply from 202.38.160.244 : bytes=56 sequence=3 ttl=255 time = 1ms
Reply from 202.38.160.244 : bytes=56 sequence=4 ttl=255 time = 3ms
Reply from 202.38.160.244 : bytes=56 sequence=5 ttl=255 time = 2ms
--202.38.160.244 ping statistics--
5 packets transmitted
5 packets received
0% packet loss
round-trip min/avg/max = 1/2/3 ms

4.4.2 tracert

Syntax
tracert [ -a source-ip ] [ -f first-TTL ] [ -m max-TTL ] [ -p port ] [ -q nqueries ] [ -w timeout ]
host
View
Any view
Parameter
-a source-ip: Configure the source IP address used by tracert command.
-f: Configure to verify the -f switch, first-TTL specifies an initial TTL, ranging from 0 to
the maximum TTL.
-m: Configure to verify the -m switch, max-TTL specifies a maximum TTL larger than
the initial TTL.
Huawei Technologies Proprietary
4-17
Chapter 4 System Maintenance Commands