Huawei quidway s3526 series Getting Started page 231

Command Manual - Routing Protocol
Quidway S3500 Series Ethernet Switches
Description
Using summary command, you can configure to activate RIP-2 automatic route
summarization. Using undo summary command, you can disable RIP-2 automatic
route summarization.
By default, RIP-2 route summarization is used.
Route aggregation can be performed to reduce the routing traffic on the network as well
as to reduce the size of the routing table. RIP-1 does not support subnet mask.
Forwarding subnet route may cause ambiguity. Therefore, RIP-1 uses route
summarization all the time. If RIP-2 is used, route summarization function can be
disabled with the undo summary command, when it is necessary to broadcast the
subnet route.
For the related commands, see rip version.
Example
# Set RIP version on the interface Vlan-interface 1 as RIP-2 and disable the route
aggregation.
[Quidway] interface Vlan-interface 1
[Quidway-Vlan-interface1] rip version 2
[Quidway-Vlan-interface1] quit
[Quidway] rip
[Quidway-rip] undo summary
Huawei Technologies Proprietary
2-17
Chapter 2 RIP Configuration Commands