Dot1X Retry - Huawei quidway s3526 series Getting Started

Command Manual - Security
Quidway S3500 Series Ethernet Switches
Parameter
interface interface-list: Ethernet interface list, represents multiple Ethernet interfaces,
in the format of interface-list = { interface-num [ to interface-num ] } & < 1-10 >.
interface-num is a single Ethernet port, in the format of interface-num = { interface-type
interface-num | interface-name }.
Description
Using the dot1x re-authenticate command, you can enable 802.1x re-authentication
on a specific port or all the authenticator ports on a device.
Using the undo dot1x re-authenticate command, you can disable 802.1x
re-authentication on a specific port or all the authenticator ports on a device.
By default, 802.1x re-authentication is disabled on all ports.
In system view, if the interface-list parameter is not specified, it means that to enable
the 802.1x re-authentication feature on all interfaces; if the interface-list parameter is
specified, it means that to enable the feature on the specified interfaces. In Ethernet
port view, the interface-list parameter cannot be specified, and you can use command
only to enable the feature on the current interface.
Before configuring 802.1x re-authentication feature on a port, you must enable the
feature both globally and on this port.
Among S3500 series ethernet switches, S3552G, S3552P, S3528G, S3528P, S3526E,
S3526E FM, S3526E FS and S3526C support this command, and S3526, S3526 FM
and S3526 FS don't.
Example
# Enable 802.1x re-authentication on port Ethernet 0/1.
[Quidway-Ethernet0/1] dot1x re-authenticate
Re-authentication is enabled on port Ethernet 0/1

1.1.11 dot1x retry

Syntax
dot1x retry max-retry-value
undo dot1x retry
View
System view
Parameter
max-retry-value: Specifies the maximum times an Ethernet switch can retransmit the
authentication request frame to the supplicant, ranging from 1 to 10. By default, the
Huawei Technologies Proprietary
1-11
Chapter 1 802.1x Configuration Commands