Databits - Huawei quidway s3526 series Getting Started

Command Manual - Getting Started
Quidway S3500 Series Ethernet Switches
Parameter
level: Specifies the command level, ranging from 0 to 3.
view: Specifies the command view, which can be any of the views supported by the
switch.
command: Specifies the command to be configured.
Description
Using command-privilege level command, you can configure the priority of the
specifically command of the specifically view. Using undo command-privilege view
command, you can restore the default command priority.
The command levels include visit, monitoring, system, and management, which are
identified as 0 through 3 respectively. The network administrator can customize the
command levels as needed.
When users log into the switch, the commands they can use depend jointly on the user
level settings and the command level settings on the user interface. If the two types of
settings differ,
For the users using AAA/RADIUS authentication, the commands they can use are
determined by the user level settings. For example, if a use is set to level 3 and the
command level on the VTY 0 user interface is level 1, he or she can only use the
commands of level 3 or lower when logging into the switch from the VTY 0 user
interface.
For the users using RSA public key authentication, the commands they can use
are determined by the command level settings on the user interface.
By default, ping, tracert, and telnet are at visit level (0); display and debugging are at
monitoring level (1); all configuration commands are at system level (2); and FTP,
XMODEM, TFTP and commands for file system operations are at management level
(3).
Example
# Configure the precedence of the command "interface" as 0.
[Quidway] command-privilege level 0 view system interface

1.1.4 databits

Syntax
databits { 7 | 8 }
undo databits
View
User interface view
Huawei Technologies Proprietary
1-3
Chapter 1 Logging in Switch Commands