Info-Center Snmp Channel; Info-Center Source - Huawei quidway s3526 series Getting Started

Command Manual - System Management
Quidway S3500 Series Ethernet Switches
This command takes effect only after system logging is started.
For the related commands, see info-center enable,display info-center.
Example
# Configure channel 0 to output log information to user terminal.
[Quidway] info-center monitor channel 0

4.5.10 info-center snmp channel

Syntax
info-center snmp channel { channel-number | channel-name }
undo info-center snmp channel
View
System view
Parameter
channel-number: Channel number, ranging from 0 to 9, that is, the system has ten
channels. By default, channel 5 is used.
channel-name: Specify the channel name. The name can be channel6, channel7,
channel8,
trapbuffer.
Description
Using info-center snmp channel command, you can configure new channel for
transmitting the SNMP information. Using undo info-center snmp channel command,
you can restore the channel for transmitting the SNMP information to default value.
For the related commands, see display snmp.
Example
# Configure channel 6 as the SNMP information channel.
[Quidway] info-center snmp channel 6

4.5.11 info-center source

Syntax
info-center source { modu-name | default } channel { channel-number |
channel-name } [ { log | trap | debug } * { level severity | state state } * ]
undo info-center source { modu-name | default } channel { channel-number |
channel-name }
channel9, console,
Huawei Technologies Proprietary
4-26
Chapter 4 System Maintenance Commands
logbuffer, loghost, monitor, snmpagent,