Cluster Switch-To - Huawei quidway s3526 series Getting Started

Command Manual - Integrated Management
Quidway S3500 Series Ethernet Switches
View
System view
Parameter
None
Description
Using cluster enable command, you can enable the cluster function on a switch. Using
undo cluster enable command, you can disable the cluster function of a switch.
By default, the cluster function is enabled on all the devices supporting cluster.
Above commands can be used on any device supporting the cluster function. When
you use the undo cluster enable command on an administrator device, the system will
delete the cluster and disable the cluster function on it. When you use it on a member
device, the system will exit the cluster and disable the cluster function on it.
Note: If the cluster function is disabled, you cannot create a cluster on the device or add
it to a cluster.
Example
# Enable the cluster function of a switch.
[Quidway] cluster enable

2.3.7 cluster switch-to

Syntax
cluster switch-to { member-num | mac-address H-H-H | administrator }
View
User view
Parameter
member-num: Member number of member device, ranging from 1 to 256.
mac-address H-H-H: MAC address of a member device.
administrator: Redirect from a member device to the administrator device.
Description
Using cluster switch-to command, you can switch between administrator device and
member devices for convenient management.
A member device in a cluster can be managed through the administrator device. The
user can operate on an administrator device and switchover to a specified member
Chapter 2 HGMP V2 Configuration Commands
Huawei Technologies Proprietary
2-18