Flow-Control; Free User-Interface - Huawei quidway s3526 series Getting Started

Command Manual - Getting Started
Quidway S3500 Series Ethernet Switches

1.1.8 flow-control

Syntax
flow-control { hardware | none | software }
undo flow-control
View
User interface view
Parameter
hardware: Configures to perform hardware flow control.
none: Configures no flow control.
software: Configures to perform software flow control.
Description
Using flow-control command, you can configure the flow control mode on AUX
(Console) port. Using undo flow-control command, you can restore the default flow
control mode.
By default, the value is none. That is, no flow control will be performed.
This command can only be performed in AUX user interface view.
Example
# Configure software flow control on AUX (Console) port.
[Quidway-ui-aux0] flow-control software

1.1.9 free user-interface

Syntax
free user-interface [ type ] number
View
User view
Parameter
type: Specifies the user interface type.
number: Specifies the absolute/relative number of the user interface. Configured
together with the type, it will specify the user interface number of the corresponding
type. If the type is not specified, number will specify an absolute user interface number.
Huawei Technologies Proprietary
1-7
Chapter 1 Logging in Switch Commands