Filter-Policy Export - Huawei quidway s3526 series Getting Started

Command Manual - Routing Protocol
Quidway S3500 Series Ethernet Switches
Table 3-15 Description of information generated by the command display ospf vlink
Field
Virtual-link
Neighbor-id
State
Interface
Cost
Type
Transit Area
Timers
Transmit Delay

3.1.26 filter-policy export

Syntax
filter-policy { acl-number | ip-prefix ip-prefix-name } export [ routing-protocol ]
undo filter-policy { acl-number | ip-prefix ip-prefix-name} export [ routing-protocol ]
View
OSPF view
Parameter
acl-number: Access control list number.
ip-prefix-name: Name of the address prefix list.
routing-protocol: Protocol advertising the routing information, including direct, bgp, rip
and static at present.
Description
Using filter-policy export command, you can configure the rule of OSPF filtering the
advertised routing information. Using undo filter-policy export command, you can
cancel the filtering rules that have been set.
By default, no filtering of the distributed routing information is performed.
Router ID of virtual-link neighbor router
State
IP address the interface on the virtual link
Route cost of the interface
Type: virtual link
ID of transit area that the virtual link passes, and it cannot be
backbone area, STUB area and NSSA area
OSPF timers, defining as follows:
Hello Interval of hello packet
Dead Interval of dead neighbors
Poll Interval of poll
Retransmit Interval of retransmitting LSA
Delay time of transmitting LSA
Huawei Technologies Proprietary
3-28
Chapter 3 OSPF Configuration Commands
Description