Rip Metricout; Rip Output - Huawei quidway s3526 series Getting Started

Command Manual - Routing Protocol
Quidway S3500 Series Ethernet Switches
Example
# Specify the additional route metric to 2 when the interface Vlan-interface 1 receives
RIP packets.
[Quidway] interface Vlan-interface 1
[Quidway-Vlan-interface1] rip metricin 2

2.1.16 rip metricout

Syntax
rip metricout value
undo rip metricout
View
Interface view
Parameter
value: Additional route metric added when transmitting a packet, ranging from 1 to 16.
By default, the value is 1.
Description
Using rip metricout command, you can configure the additional route metric to the
route when an interface transmits RIP packets. Using undo rip metricout command,
you can restore the default value of this additional route metric.
For the related commands, see rip metricin.
Example
# Set the additional route metric to 2 when the interface Vlan-interface 1 transmits RIP
packets.
[Quidway] interface Vlan-interface 1
[Quidway-Vlan-interface1] rip metricout 2

2.1.17 rip output

Syntax
rip output
undo rip output
View
Interface view
Huawei Technologies Proprietary
2-13
Chapter 2 RIP Configuration Commands