Huawei quidway s3526 series Getting Started page 424

Command Manual - QoS/ACL
Quidway S3500 Series Ethernet Switches
View
ACL view
Parameter
rule-id: Specifies a rule of an ACL with a number in the range of 0 to 127.
permit: Indicates to let the matched packets through.
deny: Indicates to reject the matched packets to pass through.
time-range name: Name of a time range, during which a rule takes effect.
Note:
The following parameters are attributes carried by the data packets. The ACL rules are
defined according to the values of these parameters.
The parameter for define a basic ACL
source-addr wildcard | any: source-addr wildcard is the source IP address and source
address wildcard, expressed in dotted decimal notation. any represents any source
address.
fragment: Indicates that the rule takes effect on fragmented packets only and will be
ignored for other packets.
The parameter of advanced ACL
protocol: This parameter is to define protocol type, which can be indicated by name, or
digit. This parameter can be icmp, igmp, tcp, udp, ip, gre, ospf or ipinip. If this
parameter takes ip, it means all the IP protocols. This parameter can be 1 ~ 255 if
indicated by digit.
source-addr wildcard | any: source-addr wildcard is the source IP address and source
address wildcard, expressed in dotted decimal notation. any represents any source
address.
dest-addr wildcard | any: dest-addr wildcard is the destination IP address and
destination address wildcard, expressed in dotted decimal notation. any represents
any destination address.
source-port operator port1 [ port2 ]: This parameter is to define the source TCP or
UDP port number. Here, operator represents port operation character, including eq
(equal to), gt (greater than), lt (less than), neq (not equal to), and range (in certain
range). Note: This parameter is available only when protocol parameter takes TCP or
UDP. port1 [ port2 ]: TCP or UDP port number of packets, expressed with characters or
numbers. The numbers are in the range of 0 to 65535 and refer to mnemonic symbol
table for character values.
Huawei Technologies Proprietary
1-22
Chapter 1 ACL Commands