Stp Edged-Port - Huawei quidway s3526 series Getting Started

Command Manual - STP
Quidway S3500 Series Ethernet Switches
The network diameter refers to the maximum count of switches on the path between
any two terminal devices.
The definition of network diameter: Maximum count of switches between the farthest
communication ends.
stp bridge-diameter command configures the switching network diameter and
determines the three time parameters of MSTP accordingly. This configuration takes
effect on CIST only but makes no sense for MSTI.
The spanning tree convergence can be speeded up, when Hello Time, Forward Delay,
and Max Age are well configured. These parameters are related to the network scale.
You can configure the network scale to get the time parameters. Upon the
user-configured bridge-diameter parameter, MSTP will automatically set Hello Time,
Forward Delay, and Max Age to moderate values. When bridge-diameter defaults to 7,
the time parameters also take their respective default values.
For the related command, see stp timer forward-delay, stp timer hello, stp timer
max-age.
Example
# Set the diameter of the switching network to 5.
[Quidway] stp bridge-diameter 5

1.1.12 stp edged-port

Syntax
stp edged-port { enable | disable }
undo stp edged-port
View
Ethernet port view
Parameter
enable: Configure the current port as an edge port.
disable: Configure the current port as a non-edge port.
Description
Using stp edged-port enable command, you can configure the current Ethernet port
as an edge port. Using stp edged-port disable command, you can configure the
current Ethernet port as a non-edge port. Using undo stp edged-port command, you
can restore the default state, i.e., non-edge port.
By default, all the switch ports are configured as non-edge port.
Huawei Technologies Proprietary
1-11
Chapter 1 MSTP Configuration Commands