Peer Timer; Reflect Between-Clients - Huawei quidway s3526 series Getting Started

Command Manual - Routing Protocol
Quidway S3500 Series Ethernet Switches
Example
# Configure the interval of the BGP peer group "test" sending the route update packet
as 10 seconds.
[Quidway-bgp] peer test as-number 100
[Quidway-bgp] peer test route-update-interval 10

4.1.50 peer timer

Syntax
peer { group-name | peer-address } timer keep-alive keepalive-interval hold
holdtime-interval }
undo peer { group-name | peer-address } timer
View
BGP view
Parameter
group-name: Name of peer group.
peer-address: IP address of the peer.
keepalive-interval: Keepalive interval to be specified. The range is 1 to 65535. By
default, its value is 60 seconds.
holdtime-interval: Holdtime interval to be specified. The range is 3 to 65535. By default,
its value is 180 seconds.
Description
Using peer timer command, you can configure the timers for a peer/peer group. Using
undo peer timer command, you can restore the timer to the default value.
The timer configured by using this command has a higher priority than the one
configured by using the timer command.
Example
# Configure Keepalive and Holdtime intervals of the peer group "test".
[Quidway-bgp] peer test timer keep-alive 60 hold 180

4.1.51 reflect between-clients

Syntax
reflect between-clients
undo reflect between-clients
Huawei Technologies Proprietary
4-42
Chapter 4 BGP Configuration Commands