Huawei quidway s3526 series Getting Started page 843

Command Manual - Auto Detecting
Quidway S3500 Series Ethernet Switches
Description
Use the display detect-group command to display configuration information about a
specified detecting group or all detecting groups.
Example
# Display configuration information about detecting group 1.
[Quidway] display detect-group 1
detect-group 1 :
detect loop time(s):
ping wait time(s):
detect retry times:
detect ip option:
group state:
register module num:
detect ip number:
detect-list
1
Table 1-1 Description on the fields of the display detect-group command
detect-group 1
detect loop time(s): 15
ping wait time(s):
detect retry times: 2
detect ip option:
group state:
detecting
register module num: 0
detect ip number:
detect-list
ip address
next-hop
15
2
2
and
not detecting
0
1
ip address
1.1.1.1
Field
Detecting group 1
The detecting interval is 15 seconds.
2 The timeout time is 2 seconds.
The retry times is 2.
The detecting result is reachable only when all the
and
specified interfaces can be successfully pinged.
not
The detecting group is not in use at present.
Count of times the detect group has been referenced.
Number of IP addresses contained in the detecting
1
group.
The number of an IP address contained in the
detecting group.
The IP address of the interface to be detected.
The IP address of the interface taken as the next hop.
Huawei Technologies Proprietary
Chapter 1 Auto Detect Configuration Commands
next-hop
1.1.1.5
Description
1-3