Huawei quidway s3526 series Getting Started page 773

Command Manual - System Management
Quidway S3500 Series Ethernet Switches
View
System view
Parameter
modu-name: Module name.
default: All the modules.
log: Log information.
trap: Trap information.
debugging: Debugging information.
level: Level.
severity: Information level, do not output information below this level. By default, the log
information level is warnings, the trap information level is debugging, the debugging
information level is debugging.
Information at different levels is as follows:
emergencies: Level 1 information, which cannot be used by the system.
alerts: Level 2 information, to be reacted immediately.
critical: Level 3 information, critical information.
errors: Level 4 information, error information.
warnings: level 5 information, warning information.
notifications: Level 6 information, showed normally and important.
informational: Level 7 information, notice to be recorded.
debugging: Level 8 information, generated during the debugging progress.
Note:
If you only specify the level for one/two of the three types of information, the level(s) of
the unspecified two/one return(s) to the default. For example, if you only define the
level of the log information, then the levels of the trap and debugging information return
to the defaults.
channel-number: Channel number to be set.
channel-name: Channel name to be set. The name can be channel6, channel7,
channel8,
trapbuffer.
state: Set the state of the information.
state: Specify the state as on or off.
channel9, console,
Huawei Technologies Proprietary
Chapter 4 System Maintenance Commands
logbuffer, loghost,
4-27
monitor, snmpagent,