Am Isolate - Huawei quidway s3526 series Getting Started

Command Manual - Network Protocol
Quidway S3500 Series Ethernet Switches
View
Ethernet port view
Parameter
all: Configures to operate on all the IP addresses (or IP address pools).
ip-pool: Configures IP address pool for access management.
address-list: Specifies IP address list in the start_ip_address [ ip_address_num ] & <
1-10 > format. start_ip_address is the start address of an IP address range in the pool.
ip_address_num specifies how many IP addresses following start_ip_address in the
range. & < 1-10 > means you can specify ten IP address ranges at most.
Description
Using am ip-pool command, you can configure the IP address pool for access
management on a port. The packet whose source IP address is in the specified pool is
allowed to be forwarded on Layer 3 via the port of the switch. Using undo am ip-pool
command, you can cancel the access management IP pool of the port.
By default, All the IP address pools for access control on the port are null and all the
packets are permitted through.
Note that if the IP address pool to be configured contains the IP addresses configured
in the static ARP at other ports, then the system prompts you to delete the static ARP to
make the later binding effective.
Example
# Configure the access management IP address pool on Ethernet0/1 and permits the
addresses from 202.112.66.2 through 202.112.66.20 and the specified 202.112.65.1 to
access the port.
[Quidway-Ethernet0/1] am ip-pool 202.112.66.2 19 202.112.65.1

9.1.3 am isolate

Syntax
am isolate interface-list
undo am isolate interface-list
View
Ethernet port view
Parameter
interface-list: Specifies a list of ports isolated from the specified port in the
{ { interface-type interface-number | interface-name } [ to { interface-type
Chapter 9 Access Management Configuration Commands
Huawei Technologies Proprietary
9-2