Ntp-Service Unicast-Peer - Huawei quidway s3526 series Getting Started

Command Manual - System Management
Quidway S3500 Series Ethernet Switches
Description
Using ntp-service source-interface command, you can designate an interface to
transmit NTP message. Using undo ntp-service source-interface command, you can
cancel the current setting.
The source address specifies where the packets are transmitted from.
You can use this command to designate an interface to transmit all the NTP packets
and take the source address of these packets from its IP address. If you do not want
any other interface to receive the acknowledgement packets, use this command to
specify one interface to send all the NTP packets.
Example
# Configure all the outgoing NTP packets to use the IP address of Vlan-Interface1 as
their source IP address.
[Quidway] ntp-service source-interface Vlan-Interface 1

7.1.17 ntp-service unicast-peer

Syntax
ntp-service unicast-peer ip-address [ version number ] [ authentication-key keyid ]
[ source-interface { interface-name | interface-type interface-number } ] [ priority ]
undo ntp-service unicast-peer ip-address
View
System view
Parameter
ip-address: Specify the IP address of a remote server.
version: Define NTP version number.
number: NTP version number, ranging from 1 to 3.
authentication-keyid: Define authentication key.
keyid: Key ID used for transmitting messages to a remote server, ranging from 0 to
4294967295.
source-interface: Specify the name of an interface.
interface-name: Specify the interface name. When a local device sends an NTP
message to a peer, the source IP address of the message is taken from the address of
the interface.
interface-type: Specify the interface type and determine an interface together with the
interface-number parameter.
Huawei Technologies Proprietary
7-13
Chapter 7 NTP Configuration Commands