Portal Auth-Network - Huawei quidway s3526 series Getting Started

Command Manual - Security
Quidway S3500 Series Ethernet Switches
Use the undo portal arp-handshake command to restore the default values.
When the direct authentication or re-DHCP authentication is adopted, a switch
handshakes with the host (user PC) passing the Portal authentication through ARP
packets. The switch sends periodically ARP packets at the specified time interval. If the
retry times exceed the allowed maximum number of retries and the user PC does not
give a response, the switch assumes abnormal handshake, disconnects from the user
PC, and notifies the Portal server.
This command is invalid for Layer 3 Portal authentication.
Example
# Set the time interval for the switch to handshake with the host to 120 seconds, and
the allowed maximum retry times to 6.
[Quidway] portal arp-handshake interval 120 retry-times 6

2.1.5 portal auth-network

Syntax
portal auth-network network-address net-mask vlan vlan_id
undo portal auth-network { network-address net-mask | vlan vlan_id | all }
View
System view
Parameter
network-address net-mask: Configures the address and subnet mask for an
authentication network segment.
vlan_id: VLAN ID, which indicates the VLAN where the port of the switch for
cross-segment access is located.
all: Removes all configured authentication network segments.
Description
Use the portal auth-network command to configure Portal authentication network
segments.
Use the undo portal auth-network command to remove the configuration.
By default, no authentication network segments are configured.
This command is only valid for Layer 3 Portal authentication.
Example
# Configure Portal authentication network segment 192.168.0.200/16.
[Quidway] portal auth-network 192.168.0.200 255.255.0.0 vlan 1
Huawei Technologies Proprietary
2-7
Chapter 2 Portal Configuration Commands