Apply Tag - Huawei quidway s3526 series Getting Started

Command Manual - Routing Protocol
Quidway S3500 Series Ethernet Switches
Description
Using apply origin command, which is one of attribute apply sub-statements of
Route-policy, you can configure to apply the route source. Using undo apply origin
command, you can cancel the apply sub-statement.
For the related commands, see if-match interface, if-match acl, if-match ip-prefix,
if-match ip next-hop, if-match cost, if-match tag, route-policy, apply ip next-hop,
apply local-preference, apply cost and apply tag.
Example
# Define one apply sub-statement. When it is used for setting route information attribute,
it sets the route source of BGP route information as igp.
[Quidway-route-policy] apply origin igp

5.1.8 apply tag

Syntax
apply tag value
undo apply tag
View
Route policy view
Parameter
value: Specifies the tag value of route information.
Description
Using apply tag command, you can configure to set the tag area of OSPF route
information. This command is one of attribute apply sub-statements of Route-policy.
Using undo apply tag command, you can cancel the apply sub-statement.
For the related commands, see if-match interface, if-match acl, if-match ip-prefix,
if-match ip next-hop, if-match cost, if-match tag, route-policy, apply ip next-hop,
apply local-preference, apply cost and apply origin.
Example
# Define one apply sub-statement. When it is used for setting route information attribute,
it sets the tag area of route information as 100.
[Quidway-route-policy] apply tag 100
Chapter 5 IP Routing Policy Configuration Commands
Huawei Technologies Proprietary
5-6