Ntp-Service Broadcast-Client - Huawei quidway s3526 series Getting Started

Command Manual - System Management
Quidway S3500 Series Ethernet Switches
undo ntp-service authentication-keyid number
View
System view
Parameter
number: Specify the key number and range from 1 to 4294967295.
value: Specify the value of the key with 1 to 32 ASCII characters.
Description
Using ntp-service authentication-keyid command, you can set NTP authentication
key. Using undo ntp-service authentication-keyid command, you can cancel the
NTP authentication key.
By default, there is no authentication key.
Only MD5 authentication is supported for the NTP authentication key settings.
Example
# Set MD5 authentication key 10 as BetterKey.
[Quidway]
BetterKey

7.1.8 ntp-service broadcast-client

Syntax
ntp-service broadcast-client
undo ntp-service broadcast-client
View
VLAN interface view
Parameter
None
Description
Using ntp-service broadcast-client command, you can configure NTP broadcast
client mode. Using undo ntp-service broadcast-client command, you can disable the
NTP broadcast client mode.
By default, the NTP broadcast client mode is disabled.
Designate an interface on the local Ethernet Switch to receive NTP broadcast
messages and operate in broadcast client mode. The local Ethernet Switch listens to
ntp-service authentication-keyid
Huawei Technologies Proprietary
Chapter 7 NTP Configuration Commands
10
7-6
authentication-mode md5