Huawei quidway s3526 series Getting Started page 254

Command Manual - Routing Protocol
Quidway S3500 Series Ethernet Switches
Table 3-10 Description of information generated by the command display ospf peer
RouterID
Address
State
Mode
Priority
DR
BDR
Dead timer expires in
31s
Neighbor has been up
for 01:14:14
# View the brief information of every peer.
<Quidway> display ospf peer brief
Area ID
0.0.0.0
0.0.0.1
Total
Table 3-11 Description of information generated by the command display ospf peer
brief
Field
Area ID
Down
Attempt
Neighbor has been up for 01:14:14
Field
Router ID of neighbor router
Address of the interface, through which neighbor router
communicates with the router
State of adjacency relation
Master/Slave mode formed by negotiation in exchanging
DD packet
Priority of DR/BDR for neighbor election
IP address of the interface of elected DR
IP address of the interface of elected BDR
If no hello packet received from the peer within this
interval, the peer will be considered to be invalid.
Time of neighbor connection
Down Attempt Init 2-Way ExStart Exchange Loading Full Total
0 0
0 0
0 0
Area ID
Initial state for OSPF to establish neighbor relation, which indicates that
OSPF router does not receive the message from a certain neighbor
router within a period of time
It is enabled in NBMA environment, such as Frame Relay, X.25 or
ATM. It indicates that OSPF router does not receive the message from
a certain neighbor router within a period of time, but still attempts to
send Hello packet to the adjacent routers for their communications with
a lower frequency.
Huawei Technologies Proprietary
Chapter 3 OSPF Configuration Commands
Description
Neighbor Statistics
0 0 0
0 0 0
0 0 0
Description
3-23
0 0 1
0 0 1
0 0 2
1
1
2