System-Guard Detect-Maxnum - Huawei quidway s3526 series Getting Started

Command Manual - Security
Quidway S3500 Series Ethernet Switches
Caution:
For S3526E, S3526E FM S3526E FS and S3526C: Before enabling system-guard
function, be sure the port priority is default value 0 and the ethernet switch doesn't
trust the cos priority of packets.
For S3526, S3526 FM and S3526 FS: The system-guard function is enabled only
after two or more VLAN interfaces are created and configured with the IP
addresses.
For S3526E, S3526E FM, S3526E FS and S3526C: After system-guard is enabled,
don't change the port priority and the mode of queue-scheduling.
Example
# Enable system-guard function.
[Quidway] system-guard enable
Success to enable system-guard task

6.1.4 system-guard detect-maxnum

Syntax
system-guard detect-maxnum number
undo system-guard detect-maxnum
View
System view
Parameter
number: Max detection count of system guard, ranging from 1 to 100.
Description
Using system-guard detect-maxnum command, you can set the max detection count
of affected hosts. Using undo system-guard detect-maxnum command, you can set
the max detection count of affected hosts to the default value.
By default, the max detection count of affected hosts is 30.
Example
# Set the max detection count of affected hosts to 50.
[Quidway] system-guard detect-maxnum 50
Chapter 6 System-guard Configuration Commands
Huawei Technologies Proprietary
6-4