Display Arp - Huawei quidway s3526 series Getting Started

Command Manual - Network Protocol
Quidway S3500 Series Ethernet Switches
Description
Using debugging arp packet command, you can enable ARP debugging. Using undo
debugging arp packet command, you can disable the corresponding ARP debugging.
By default, undo ARP debugging is enabled.
For the related command, see arp static, display arp.
Example
# Enable ARP packet debugging.
<Quidway> debugging arp packet
*0.771346-ARP-8-S1-arp_send:Send
sender_eth_addr :
00e0-fc00-3500,sender_ip_addr
0000-0000-0000
, target_ip_addr : 10.110.91.193
*0.771584-ARP-8-S1-arp_rcv:Receive
sender_eth_addr
: 0050-ba22-6fd7,
00e0-fc00-3
500, target_ip_addr : 10.110.91.159
Table 2-1 Output description of the debugging arp packet display
operation
sender_eth_addr
sender_ip_addr
target_eth_addr
target_ip_addr

2.1.10 display arp

Syntax
display arp [ dynamic | static | ip-address ]
View
Any view
sender_ip_addr
Field
Kind of ARP packets: 1 ARP request packet; 2 ARP reply
packet
Ethernet address of the sender
IP address of the sender
Target Ethernet address. If the packet is ARP request packet,
the target IP address will be 0
Target IP address
Huawei Technologies Proprietary
Chapter 2 ARP Configuration Commands
an ARP Packet,
: 10.110.91.159,
an ARP Packet,
: 10.110.91.193,
Description
2-7
operation : 1,
target_eth_addr :
operation : 2,
target_eth_addr :