Network Connection Test Commands; Ping - Huawei quidway s3526 series Getting Started

Command Manual - System Management
Quidway S3500 Series Ethernet Switches
information needed. In this case, you can use display diagnostic-information
command.
Example
# Display all system configuration information
<Quidway> display diagnostic-information
This operation may take a few minutes, continue?[Y/N]y
---------------display clock---------------
20:12:39 UTC Mon 2000/5/8
---------------display version---------------
Huawei Versatile Routing Platform Software
VRP (tm) software, Version 3.10
Copyright (c) 2000-2002 HUAWEI TECH CO., LTD.

4.4 Network Connection Test Commands

4.4.1 ping

Syntax
ping [ -a ip-address ] [-c count ] [ -d ] [ -f ] [ -h ttl ] [ -i {interface-type interface-num |
interface-name } ] [ ip ] [ -n ] [ - p pattern ] [ -q ] [ -r ] [ -s packetsize ] [ -t timeout ] [ -tos
tos ] [ -v ] host
View
Any view
Parameter
-a ip-address: Specify the source IP address to transmit ICMP ECHO-REQUEST.
-c: count specify how many times the ICMP ECHO-REQUEST packet will be
transmitted, ranging from 1 to 4294967295.
-d: Configure the socket to be in DEBUGGING mode.
-f: Drop the packets which are larger than the MTU instead of fragmenting them.
-h ttl: Configure TTL value for echo requests to be sent, range from 1 to 255.
ip: Choose IP ICMP packet.
-i: Configure to choose packet sent on the interface.
interface-type: Specify the interface type.
interface-num: Specify the interface number.
interface-name: Specify the interface name.
Huawei Technologies Proprietary
4-15
Chapter 4 System Maintenance Commands