Huawei quidway s3526 series Getting Started page 796

Command Manual - System Management
Quidway S3500 Series Ethernet Switches
Parameter
username: Specify the user name, ranging from 1 to 32 bytes.
groupname: Specify the group name corresponding to that user, a character string at
the length ranging from 1 to 32 bytes.
v1: Configure to use V1 safe mode.
v2c: Configure to use V2c safe mode.
v3: Configure to use V3 safe mode.
authentication-mode: Specify the safety level as authentication required.
md5: MD5 algorithm is adopted in authentication. MD5 authentication uses the
128-digit password. Computation speed of MD5 is faster than that of SHA
sha: SHA algorithm is adopted in authentication. SHA authentication uses the 160-digit
password. Computation speed of SHA is slower than that of MD5, but with higher
security.
authpassword: Specify the authentication password with a character string, ranging
from 1 to 64 bytes.
privacy-mode: Specify the safety level as encrypted.
des56: Specify the authentication protocol as DES.
privpassword: Specify the encryption password with a character string, ranging from 1
to 64 bytes.
acl acl-list:Set access control list for this user based on USM name
Description
Using snmp-agent usm-user command, you can add a new user to an SNMP group.
Using undo snmp-agent usm-user command, you can cancel a user from SNMP
group.
SNMP engineID (for authentication) is required when configuring remote user for an
agent. This command will not be effective without engineID configured.
For V1 and V2C, this command will add a new community name. For V3, it will add a
new user for an SNMP group.
Example
# Add a user wang for huawei (an SNMP group), configures to authenticate with MD5
and sets authentication password as pass.
[Quidway] snmp-agent usm-user v3 wang huawei authentication-mode md5 pass
Huawei Technologies Proprietary
5-17
Chapter 5 SNMP Configuration Commands