Realpresence Collaboration Server (Rmx) 2000 - Polycom realpresence 1800 Administrator's Manual

RealPresence Collaboration Server (RMX) 2000

On a RealPresence Collaboration Server (RMX) 2000, one RTM LAN card is required.
For more information see the RealPresence Collaboration Server (RMX) 2000 Hardware Guide,
Installing or Replacing the RTM
● Connect the additional LAN cable to LAN 1 port on the RTM LAN.
● In the Setup> System Configuration > System Flags dialog box, add the flag
RMX2000_RTM_LAN and set it to YES to activate the installed RTM LAN card.
● On the RealPresence Collaboration Server (RMX) 2000, LAN Redundancy can be enabled
simultaneously with Multiple Networks. To enable the Multiple Networks option, set the
MULTIPLE_SERVICES flag to YES.
● A system reset is required when adding the RMX2000_RTM_LAN flag.
RealPresence Collaboration Server (RMX) 4000
● Connect the additional LAN cable to LAN 1 port on the RTM LAN.
● On the RealPresence Collaboration Server (RMX) 4000, LAN Redundancy can be enabled
simultaneously with Multiple Networks. To enable the Multiple Networks option, set the
MULTIPLE_SERVICES flag to YES.
● If required, reset the Collaboration Server.
On all systems:
● LAN Redundancy can be disabled by setting the LAN_REDUNDANCY System Flag to NO.
● If the LAN_REDUNDANCY System Flag value set to NO, the LAN 2 port must be connected to the
IP network.
On the RMX 2000/4000, full media redundancy is supported if only one IP Network Service is defined
per media card.
Hardware Monitor Indications
When LAN Redundancy is enabled on the Collaboration Server, LAN 2 port is Active. With LAN
redundancy, when LAN LEDs are lit they indicate that a physical connection of the cables is present but
does not indicate their activity status. In the Hardware Monitor pane the Lan List displays the Collaboration
Server LAN ports together with their Status indication.
Polycom, Inc.
LAN.
IP Network Services
529