Polycom realpresence 1800 Administrator's Manual page 858

4 Optional. If CSR was selected as the Certificate Method:
a Click Create Certificate Request.
The Create Certificate Request dialog box is displayed with the Common Name field filled in.
Your network administrator may have specific requirements for the content of these fields. In the
absence of any other guidance, it is recommended that the following information be contained in
this field:
 If DNS is being used, enter the DNS Fully Qualified Domain Name (FQDN) of the
Collaboration Server Management Network Interface. This should match the Host Name and
Domain configured in the Management Network Properties dialog box.
 If DNS is not being used in your deployment, enter the IP Address of the Collaboration Server
Management Network Interface.
b Complete the Certificate Request fields.
The two additional fields are defined as:
 Subject Alternative Name (SAN) - This field is required when using EAP-TLS in conjunction
with a Network Policy Server (MS-NPS). It allows the optional inclusion of:
- Principle Name
- DNS Name:
- Long – FQDN
- Short - Host only
- IP Address (IPv4 and IPv6)
When the Subject Alternative Name (SAN) check box is selected the input box becomes
active, allowing the user to modify the example values provided, to match local certificate
requirements and delete those that are not applicable.
The user can add up to 20 different SANs.
Your network administrator may have specific requirements for the content of these fields. In
the absence of any other guidance, it is recommended that the following information be
contained in the SAN fields:Collaboration Server
- If DNS is being used, include a SAN field with "DNS Name=<FQDN of the Collaboration
Server Management Network Interface>", for example: DNS Name=rmx@example.com
- If Principal Names are being used, include a SAN field with "Principal Name=<Principal
Name assigned to your Collaboration Server>, for example:
Principal Name=rmx@example.com
- If IPv4 is enabled on the interface, include an IP Address field, for example:
IP Address=1.1.1.1
- If IPv6 is enabled on the interface, include an IP Address field, for example:
IP Address= 2001:DB8:1::100
If an incorrect SAN type is entered, an error message, Unsupported SAN type, is displayed
when the Send Details button is clicked.
Polycom, Inc.
Ultra Secure Mode
827