The System Flags - Polycom realpresence 1800 Administrator's Manual

3 Click OK to close the System Flags dialog box.

The System Flags

This section describes the system flag throughout the system.
The MCMS System Flags
The MCMS system flags, viewed via the MCMS_PARAMETERS_USER tab, are responsible for the general
system logic.
The table below summarizes the general MCMS system flags active in the system, alphabetically.
The Add? Column
The Add? column indicates whether the flag requires manual addition before its value can be
modified to values other than the default.
It is usually applicable to flags the user is not likely to require modifying their default value, but under
more unusual circumstances.
The MCMS System Flags
Flag
802_FIPS_MODE
ACCEPT_VOIP_DTMF_TYPE
Polycom®, Inc.
Description
Controls availability of MD5 Authentication Protocol.
Range:
• YES - MD5 is not available for selection in the user interface.
• NO - MD5 is available for selection in the user interface.
Default:
• Standard Security Mode - NO
• Ultra Secure Mode - YES
Defines the type of DTMF tones (inband) or digits (outband) that
the Collaboration Server will accept in VOIP calls.
Range:
• 0 - Auto (default):
Inband or outband DTMF tones/digits are accepted depending
on the endpoint's current setting. If the endpoint switches from
inband to outband, and vice versa, the value of the
SET_DTMF_SOURCE_DIFF_IN_SEC flag determines the
time interval after which both inband and outband tones/digits
will be accepted.
• 1 - Outband (H.245) only
• 2 - Inband only
System Configuration Flags
Add?


760