Polycom realpresence 1800 Administrator's Manual page 808

The MCMS System Flags
Flag
IP_LINK_ENVIRONMENT
IP_RESPONSE_ECHO
IPV6_AUTO_ADDRESS_CONFIGU
RATION_METHOD
ISDN_COUNTRY_ CODE
ISDN_IDLE_CODE_E1
ISDN_IDLE_CODE_T1
ISDN_NUM_OF DIGITS
Polycom®, Inc.
Description
In H.239-enabled MIH Cascading, when MGC is on level 1, setting
this flag to YES will adjust the line rate of HD Video Switching
conferences run on the RealPresence Collaboration Server (RMX)
1800/2000/4000 from 1920Kbps to 18432, 100bits/sec to match
the actual rate of the IP Only HD Video Switching conference
running on the MGC.
Note: If the flag MIX_LINK_ENVIRONMENT is set to NO, the
IP_ENVIRONMENT_LINK flag must be set to YES.
When the System Flag value is YES, the Collaboration Server will
respond to ping (IPv4) and ping6 (IPv6) commands. When set to
NO, the Collaboration Server will not respond to ping and ping6
commands.
SLAAC (Stateless Address Auto Configuration) and DHCPv6
related system behavior is controlled by setting this flag's value as
required.
Range: AUTO / SLAAC
AUTO—(default) Use DHCPv6 first in case of failure use SLAAC.
SLAAC—Use SLAAC only.
The name of the country in which the MCU is located.
Default: COUNTRY_NIL
The Idle code (silent), transmitted on the ISDN E1 B channels,
when there is no transmission on the channels.
Default: 0x54
The Idle code (silent), transmitted on the ISDN T1 B channels,
when there is no transmission on the channels.
Default: 0x13
When using ISDN Overlap sending dialing mode, this field holds
the number of digits to be received by the MCU.
Default: 9
System Configuration Flags
Add?







777