Polycom realpresence 1800 Administrator's Manual page 795

The MCMS System Flags
Flag
CONF_GATHERING_DURATION_S
ECONDS
CONTENT_SLAVE_LINKS_INTRA_
SUPPRESSION_IN_ SECONDS
CONTENT_SPEAKER_INTRA_SUP
PRESSION_IN_SECONDS
CP_REGARD_TO_INCOMING_SET
UP_RATE
CPU_BONDING_LINK_MONITORI
NG_FREQUENCY
Polycom®, Inc.
Description
The value of this System Flag sets the duration of the Gathering
Phase in seconds. The Gathering Phase duration of the
conference is measured from the scheduled start time of the
conference.
Range: 0 - 3600
Default: 180
For more information see
Defines the interval, in seconds, during which the Collaboration
Server is allowed to forward an Intra Request received from any of
the Slave Cascading Links. The Slave Cascading Link can be
connected to the local Collaboration Server, to an MCU on a
higher cascade level or to the Content sharer.
The first Intra request that is received from any of the Slave MCUs
connected to the Collaboration Server starts the interval counter
and is forwarded to the next level MCU or to the Content sharer.
All other Intra requests that are received within this interval are
registered but ignored. After an interval of <flag value> seconds,
the system checks if during the last interval any additional Intra
requests were registered. If there is at least one Intra request it will
be forwarded. If there is no additional Intra request not no action is
taken other than to wait for the next cycle.
This filtering process is repeated every <flag value> seconds.
Default: 30
This flag controls the requests to refresh (intra) the content sent
from the Collaboration Server system to the content sender as a
result of refresh requests initiated by other conference
participants.
Enter the interval in seconds between the Intra requests sent from
the Collaboration Server to the endpoint sending the content to
refresh the content display. Refresh requests that will be received
from endpoints within the defined interval will be postponed to the
next interval.
Default setting: 5
For use in the Avaya Environment.
If set to YES, the RealPresence Collaboration Server calculates
the line rate for incoming calls in CP conferences, according to the
line rate which is declared by the endpoint in the H.225 setup
message.
If set to NO, the rate is calculated according to the conference line
rate regardless of the rate in the H.225 setup message.
Default: YES.
Used when using the MII Monitor for troubleshooting
networks.This flag sets the MII Polling Interval in milliseconds. A
value of zero disables MII monitoring.
Default: 100
System Configuration Flags
Video Preview (AVC Participants Only)
Add?





764