Gateway Calls - Polycom realpresence 1800 Administrator's Manual

Gateway Calls

The RealPresence Collaboration Server (RMX) can be used as a gateway that provides connectivity across
different physical networks and translates multiple protocols for point-to-point rich media communications.
The Collaboration Server supports a range of video and audio algorithms. It allows sites with different frame
rates, connection speeds, audio algorithms, video resolutions and network protocols to transparently
connect with one another. It also enables multipoint conference creation from an endpoint.
A special conference acting as a Gateway Session is created on the Collaboration Server. It includes one
dial-in connection of the endpoint initiating the Gateway Session and one or several dial-out connections to
endpoints. It provides connectivity between the various protocols: H.323, SIP, ISDN and PSTN.
To enable the gateway functionality a special Gateway Profile is defined on the Collaboration Server.
Note: Gateway Functionality
Gateway calls are supported with AVC calls only.
Gateway functionality is not supported by Collaboration Server (RMX) 1800 with no DSP cards.
Gateway Functionality
The following features and capabilities are supported in gateway calls:
● Gateway Sessions are in CP Mode only.
If Video Switching is selected in the Profile assigned to the Gateway Session, the system ignores this
setting and will run the Gateway Session in CP mode.
 Gathering phase is not supported in gateway calls, even if it is defined in the Profile assigned to
the Gateway Profile.
● Sharing Content using H.239 protocol
● FECC.
Note: Only IP participants can use FECC as it is not supported by the ISDN protocol.
● Recording.
Note: The Recording Link is not considered as a participant and therefore, the gateway session will
automatically end when only one of the participants remains connected in addition to the recording
link. The video of the Recording Link is not included in the display of the video of the gateway call.
● Forwarding of DTMF codes from the Gateway Session to a conference running on another gateway,
MCU or DMA. This enables the participant to enter the required conference and/or chairperson
password when connecting to another conference.
DTMF forwarding is enabled when there are only two participants connected to the Gateway Session.
● Forwarding of all DTMF codes sent by participants in the Gateway Session to all PSTN and ISDN
participants. This is enabled by adding the
ALWAYS_FORWARD_DTMF_IN_GW_SESSION_TO_ISDN System Flag to system.cfg and
setting its value to YES.
● Up to 80 gateway calls may be run on a fully configured MCU.
● Gateway Profiles are included in the Backup and Restore Configuration operations.
Polycom®, Inc. 630