The Cs System Flags - Polycom realpresence 1800 Administrator's Manual

The MCMS System Flags
Flag
V35_ULTRA_SECURED_SUPPORT
VIDEO_BIT_RATE_REDUCTION_P
ERCENT
VSW_CIF_HP_THRESHOLD_BITR
ATE
VSW_HD_1080p_HP_THRESHOLD
_BITRATE
VSW_HD_720p30_HP_THRESHOL
D_BITRATE
VSW_HD_720p50_60_HP_THRES
HOLD_BITRATE
VSW_RATE_TOLERANCE_PEREC
ENT
VSW_SD_HP_THRESHOLD_BITR
ATE
WRONG_NUMBER_DIAL_RETRIE
S

The CS System Flags

The Call Signaling (CS) parameters are responsible for implementing the call protocol and signaling.
Polycom®, Inc.
Description
This flag must be set to YES when deploying a Serial Gateway
S4GW. This flag is applicable regardless of security mode.
Indicates the percentage of actual reduction in bit rate sent from
the RMX to the endpoint (negotiated bit rate is not reduced). This
flag is applicable only when traffic shaping is enabled (see
ENABLE_RTP_TRAFFIC_SHAPING).
Range: 0-60
Default: 15
Controls the Minimum Threshold Line Rate (kbps) for CIF
resolution for High Profile-enabled VSW conferences.
Default: 64
Controls the Minimum Threshold Line Rate (kbps) for HD1080p
resolution for High Profile-enabled VSW conferences.
Default: 1024
Controls the Minimum Threshold Line Rate (kbps) for HD720p30
resolution for High Profile-enabled VSW conferences.
Default: 512
Controls the Minimum Threshold Line Rate (kbps) for HD720p50
and HD720p50 resolutions for High Profile-enabled VSW
conferences.
Default: 832
Determines the percentage of bandwidth that can be deducted
from the required bandwidth to allow participants to connect to the
conference.
For example, a value of 20 will allow a participant to connect to the
conference if the allocated line rate is up to 20% lower than the
conference line rate (or between 80% to 100% of the required
bandwidth).
Range: 0 - 75
Default: 0
Controls the Minimum Threshold Line Rate (kbps) for SD
resolution for High Profile-enabled VSW conferences.
Default: 128
The number of re-dial attempts for a wrong destination number or
a wrong destination number time-out.
Range: 0 - 5
Default: 3
A flag value of 0 means that no redials are attempted.
System Configuration Flags
Add?









804