Enabling, Disabling And Modifying The White List - Polycom realpresence 1800 Administrator's Manual

● The White List can hold up to 100 entries. An error message is displayed when exceeding this limit.
● Access is blocked at the firewall for devices with IP addresses not listed in the White List.
● The White List is saved during Backup, Restore and Upgrade processes.
● Changes to the White List are written to the Auditor Event File.
● Alterations to the White List do not require a system reset.

Enabling, Disabling and Modifying the White List

The use of White List in the environment can be enabled or disabled in the Management Network Service
- White List dialog box.
To enable, disable, view or modify the White List:
1 In the RMX Management pane, click the IP Network Services.
The IP Network Services pane is displayed.
2 In the IP Network Services list pane, double-click the Management Network entry.
The Management Network dialog box is displayed.
3 Click the WhiteList tab.
The WhiteList dialog box is displayed.
 If there are no entries in the White List, it is disabled to prevent lock out.
 If the White List is disabled none of the IP addresses in the list are displayed.
 The Add and Remove buttons are only active if the Enable Whitelist check box is selected.
4 Select the Enable Whitelist check box.
All IP addresses in the list are displayed and the Add and Remove buttons become active.
Polycom, Inc.
Ultra Secure Mode
871