Add An Mlpp Network Domain; Alternative Network Address Type (Anat); Multipoint Conference On A Realpresence Collaboration Server; Enable Call Escalation Of Point-To-Point Calls - Polycom RealPresence Group Series Administrator's Manual

5. Click Save.

Add an MLPP Network Domain

You can add an MLPP network domain for your RealPresence Group Series system.
Procedure
1. To add a network domain, click
domain in the define MLPP network domains task above.
2. Click Save when you are finished configuring the settings to save your changes.

Alternative Network Address Type (ANAT)

ANAT signaling is used for IPv4 and IPv6 support in AS-SIP and is only useful in AS-SIP environments.
When AS-SIP is enabled, and dual stack (IPV4 and IPV6) is enabled, ANAT signaling is enabled.
Consider the following best practices when you enable AS-SIP on a RealPresence Group Series system:
• Be sure to register the system only to AS-SIP-aware proxy/registrar servers, because AS-SIP
signaling can be incompatible with other types of proxy/registrar servers.
• If the Cisco Telepresence Interoperability Protocol (TIP) software option is installed, turn off TIP
signaling on the RealPresence Group Series endpoint by going to Admin Settings > Network >
Dialing Preference > Dialing Options and disabling the TIP setting. TIP signaling is incompatible
with AS-SIP signaling.
Multipoint Conference On a RealPresence
Collaboration Server
You can enable users to create an impromptu conference call during an active SIP call. To do this, you
must configure RealPresence Group Series systems to escalate new calls to an RMX conference call.
Polycom recommends that you disable adhoc call escalation to make calls through an internal MCU.
For information on configuring a SIP conference factory on a DMA system or locating the conference
factory ID, see the RealPresence DMA System v9.0.0 Operations Guide.

Enable Call Escalation of Point-to-Point Calls

You can enable point-to-point call escalation on your system.
Procedure
1. In the system web interface, navigate to Admin Settings > Network > IP Network > Adhoc Call
Escalation.
2. Select Enable automatic call escalation of point-to-point to an external MCU.
3. For the Conference Factory ID, enter the ID associated with the SIP conference factory on your
RealPresence DMA system.
Polycom, Inc.
and then configure the same settings for the new network
Configuring Network Settings
73