Adding An Snmp V3 Credential - Brocade Communications Systems Brocade 8/12c User Manual

TABLE 49
SNMP credential
type
v3
1
MD5 - message digest algorithm 5
2
SHA - secure hash algorithm
3
HMAC - hash-based message authentication
4
CBC - cipher block chaining
5
CFB - cipher feedback
By default, the Management application receives SNMP v1 and v2c traps from Brocade IP products
that have any SNMP community strings. You can accept or restrict SNMP v1 and v2c traps by
clicking one of the following check boxes in the Event Reception dialog box:
•
•
•
For information about how to configure SNMP credentials, refer to
on page 857 or

Adding an SNMP v3 credential

To add an SNMP v3 credential, complete the following steps:
1. Select Monitor > SNMP Setup > Event Reception.
2. Select an SNMP v3 credential from the SNMP v3 Credentials list on the Event Reception dialog
3. Click Add.
Brocade Network Advisor SAN User Manual
53-1002167-01
SNMP security and authentication (Continued)
Privacy protocol
Authentication
Privacy protocol
Do not accept SNMP v1/v2c traps
Use this option to turn off receiving SNMP v1\v2c traps. If selected, the Management
application will not receive any SNMP v1 and v2c traps.
Accept SNMP v1/v2c traps with any community string
Use this option to turn on receiving SNMP v1 and v2c traps with any community string.
Accept SNMP v1/v2c traps with only these community strings
Use this option to turn on receiving SNMP v1 and v2c traps with only the specified
community strings.
"Adding an SNMP v1 or v2c community string"
The Event Reception dialog box displays.
box.
The Add SNMP v3 Credentials dialog box, shown in
Authentication Result
MD5 or SHA Provides authentication based on
the HMAC-MD or HMAC-SHA
algorithms.
Provides privacy based on
CBC_DES
"Adding an SNMP v3 credential"
on page 858.
Figure 377, displays.
30
SNMP traps
4 5
or CFB_AES_128 .
857