Adjustment Of The Installation Position Of The Shutter Drive Gear - Konica Minolta bizhub 362 Service Manual

8. Mechanical adjustment
[1]
[2]
[4]
8.2 Adjustment of the Installation Position of the Shutter Drive
Gear
NOTE
Make this adjustment after any of the following procedures has been performed.
• When any of gear 1, 2, or 3 has been replaced.
• When gears 1, 2, and 3 has been disassembled.
[1]
30
4. Open the Front Door.
5. Turn the dial [1], and move the sta-
[3]
pler forward.
6. Loosen the screw [2], and remove
the cover [3].
4349F3C505DA
7. Loosen two adjustment screws [4]
and move the Stapler Unit [5] in the
direction of the arrow to make the
adjustment.
8. Make another copy and check the
[5]
staple position.
4349F3C504DA
1. Set three gears.
[2]
NOTE
• Set the gears so that the marks on
[1]
Gears 1 and 3 [1] are aligned with
the rib of Gear 2 [2] as shown on
the right.
4349F3C507DA
Field Service Ver. 1.0 Dec. 2008