Maintenance Mode; Maintenance Mode Function Setting Procedure - Konica Minolta bizhub 362 Service Manual

Field service

Hide thumbs Also See for bizhub 362:

Table of Contents

8. Maintenance Mode

Maintenance Mode

A. Procedure

1. Press the Utility/Counter key.

2. Touch [Check Detail].

3. Press the following keys in this order.

Stop → 0 → 0 → Stop → 0 → 2

4. Touch [Maintenance Mode].

5. Type the 8-digit service code and touch [Enter]. (Default value: 00000000)

• When [END] is touched after a wrong service code has been entered, the Basic

screen reappears.

• At the fourth access after entries of three wrong access codes, [END] is not avail-

able on the screen. It is therefore necessary to turn OFF and ON the Main Power

• If you forget the service code, it becomes necessary to replace the RAMS Board

with a new one. Take necessary steps not to forget the service code.

• The RAMS Board is not available as a replacement part. If it requires replacement,

contact Office Printing Support Division by way of CSES.

6. The Maintenance Mode menu will appear.

• To change the service code, see "Service Security Mode."

• Touch the [Exit] key.

• The Maintenance mode is not disclosed to users. After the job is completed, there-

fore, be sure to exit the mode by turning OFF and ON the Main Power Switch.

Field Service Ver. 1.0 Dec. 2008

4040F3E562DA

Show Quick Links

Table of Contents

Bizhub 282 Bizhub 222