10.3 Settings In The Tech. Rep. Choice; System Set - Konica Minolta bizhub 362 Service Manual

Field Service Ver. 1.0 Dec. 2008

10.3 Settings in the Tech. Rep. Choice

10.3.1

System Set

A. Auto Paper Configuration
• To select whether the paper source is selected according to the results of the original
Functions size detection or whether the nearest larger size is selected according to the marketing
region.
<Inch/Metric>
• <Metric> or <Inch> is displayed according to the applicable marketing area.
Use
<Inches>
• All original sizes detected are corrected to ones in mm.
• The default setting is "Inch/Metric".
<For U.S.>
Setting/
Procedure
<For Europe and Others>
B. Priority Foolscap
Functions • To set the paper size for foolscap.
Use • To change the paper size for foolscap.
• Select the foolscap paper size from among the following four.
• The default setting is "F: 330 mm, C: 210 mm".
Setting/
Procedure
C. Simplex/Duplex
• To select whether or not the [1→1] setting is available for the [Default Setting Simplex/
Functions
Duplex] function in User's Choice.
<Simplex & Duplex>
• To display all modes in [Default Setting Simplex/Duplex] of User's Choice.
Use
<Duplex Only>
• To display Duplex only in [Default Setting Simplex/Duplex] of User's Choice.
• The default setting is "Simplex & Duplex".
Setting/
Procedure
"Inch/Metric" Inches
"Inch/Metric" Metric
F: 330 mm "F: 330 mm"
C: 203 mm "C: 210 mm"
"Simplex & Duplex"
10. Tech. Rep. Mode
F: 330 mm F: 330 mm
C: 216 mm C: 220 mm
Duplex Only
157