Konica Minolta bizhub 362 Service Manual page 75

3. Periodical check
[11]
13. Remove the mylar sheets that were attached in step 10.
[14]
[16]
[15]
18. Turn ON the main power switch.
19. Select Tech. Rep. Mode → [Function] → [F8] and press the Start key.
NOTE
• After replacing the developer, be sure to execute F8 under Function of Tech. Rep.
Mode.
• When the main power switch is turned ON, execute F8 quickly.
36
A
4040F2C583DB
[12]
4040F2C584DB
[13]
4040F2C585DB
[15]
[17]
4040F2C586DB
Field Service Ver. 1.0 Dec. 2008
12. Set the developer [11] while rotating
the gear in the direction of the arrow.
NOTE
• Not touching the gear of A side.
• Be sure not to let starter get inside
the collar.
14. Reinstall the Toner Supply Port [12].
15. Using three screws [13], secure the
Developer Scattering Prevention
Plate [14].
16. Install the four screws [15] to secure
the New Photo Conductor Unit [16]
and Developing Unit [17].
17. Install the IU in the copier.