Fns Adjustment Of The Stapler Drive Belt Position - Konica Minolta CF5001 Service Manual

Konica minolta cf5001 laser mfp service manual

Hide thumbs Also See for CF5001:

Table of Contents

OTHER ADJUSTMENTS

9.19 FNS adjustment of the sta-

pler drive belt position

A. Procedure

• This adjustment is performed only if the posi-

tion between the drive belt and the gear is dis-

placed during another adjustment by mistake.

1. Open the finisher door and pull out the stacker

2. Remove the rail stopper screws for the stacker

unit. Then, pull out the stacker unit further.

• To avoid the finisher from falling, make sure to

place a support under the stacker unit.

3. Remove the following parts.

• Rear cover

• Stapler unit cover

4. Insert the stacker unit.

5. Loosen 2 screws (M3) [2] for the staple slide

pulley/B [1] from the rear side with the hexago-

nal wrench [3].

6. Move the stapler and clincher simultaneously

toward center until they contacts with the bear-

• Make sure to move them simultaneously. The

flat-stapling stopper may be damaged at the

metal frame of the stapler if they are moved

individually.

CF5001 Field Service Ver.1.0 Sep 2003