Konica Minolta bizhub 362 Service Manual page 172

Field Service Ver. 1.0 Dec. 2008
• Subnet Mask
Functions • To set the subnet mask of the device used in the network.
• To enter the subnet mask of the machine.
Use
• Use this function when [IP Input] is selected for [DHCP].
Setting/ • IP address Version 4 format
Procedure [0 to 255] . [0 to 255] . [0 to 255] . [0 to 255]
• Gateway
Functions • To set the gateway address of the device used in the network.
• To enter the gateway address of the machine.
Use
• Use this function when [IP Input] is selected for [DHCP].
Setting/ • IP address Version 4 format
Procedure [0 to 255] . [0 to 255] . [0 to 255] . [0 to 255]
• Self-Domain Name
Functions • To set the domain name of the local machine.
Use • To enter the domain name of the local machine.
1. Touch the [Self-Domain Name].
Setting/
2. Enter the domain name of the local machine from the 10-Key Pad or the keyboard on
Procedure
the screen and then touch [Enter].
• Network Board Set
Network Board Speed
Functions • To set the data transfer rate of the Network Board.
Use • To set a specific network data transfer rate.
• The default setting is "Auto".
NOTE
Setting/
• Be sure to set the correct transfer rate so as to ensure that communications are
Procedure
carried out correctly.
• If the network data transfer rate has been changed, be sure to turn OFF the Main
Power Switch of the machine, wait for 10 sec. or more, and then turn the switch
ON again.
Duplex
Functions • To set the packet transmission/reception mode when the switching hub is connected.
• To change the setting between Full Duplex and Half Duplex.
Use
• Use this function when Network Board Speed has been set to [100M] or [10M].
• The default setting is "Half Duplex".
Setting/
NOTE
Procedure
• If the Duplex setting has been changed, be sure to turn OFF the Main Power
Switch of the machine, wait for 10 sec. or more, and then turn the switch ON
again.
"Auto" 100M
"Half Duplex" Full Duplex
8. Utility/Counter Mode
10M
133