Konica Minolta bizhub 362 Service Manual page 377

2. Firmware upgrade
NOTE
• Be sure to turn ON the sub power switch first before turning ON the main power
switch.
4. Turn ON the main power switch.
[2]
8. Turn ON the main power switch.
9. Call the Tech. Rep. Mode to the screen.
See P.154 of the main body service manual.
10. Select [ROM Version].
11. Make sure if the version of Firmware is updated.
4
5. The firmware upgrading sequence
will start.
6. When the upgrading sequence is
completed, which is notified by the
message "FINISH" appearing on the
screen, turn OFF the main power
switch.
NOTE
• NEVER turn OFF the main power
4040F2C749DA switch until the message "FINISH"
appears on the screen.
7. Remove the Compact flash card [2]
from the slot.
4040F2C597DA
Field Service Ver. 1.0 Dec. 2008